F-86 Sabre

F-86 Sabre

F-86 Sabre

The maiden flight of The North American F-86 Sabre fighter, ( Sabrejet) occurred on 1 October 1947 with George Welch at the controls, from Muroc Dry Lake (now Edwards AFB), California. Produced by North American Aviation, the Sabre is best known as the United States’ first swept wing fighter which could counter the similarly-winged Soviet MiG-15 in high-speed dogfights over the skies of the Korean War (1950-53). Considered one of the best and most important fighter aircraft in that war, the F-86 is also rated highly in comparison with fighters of other eras.Although it was developed in the late 1940s and was outdated by the end of the ’50s, the Sabre proved versatile and adaptable, and continued as a front-line fighter in numerous air forces until the last active operational examples were retired by the Bolivian Air Force in 1994. Its success led to an extended production run of more than 7,800 aircraft between 1949 and 1956, in the U.S., Japan and Italy. Variants were built in Canada and Australia. The Canadair Sabre added another 1,815 airframes, and the significantly redesigned CAC Sabre (sometimes known as the Avon Sabre or CAC CA-27), had a production run of 112. The Sabre was by far the most-produced Western jet fighter, with total production of all variants at 9,860 units.

North American had produced the propeller-powered P-51 Mustang in World War II, which saw combat against some of the first operational jet fighters. By late 1944, North American proposed its first jet fighter to the U.S. Navy which became the FJ-1 Fury. It was an unexceptional transitional jet fighter which had a straight wing derived from the P-51. Initial proposals to meet a United States Army Air Forces (USAAF) requirement for a medium-range, single-seat, high-altitude jet-powered day escort fighter/fighter bomber were drafted in mid-1944.In early 1945, North American Aviation submitted four designs. The USAAF selected one design over the others, and granted North American a contract to build three examples of the XP-86 (eXperimental Pursuit). Deleting specific requirements from the FJ-1 Fury, coupled with other modifications, allowed the XP-86 to be lighter and considerably faster than the Fury, with an estimated top speed of 582 mph (937 km/h), versus the Fury’s 547 mph (880 km/h).[6] Despite the gain in speed, early studies revealed the XP-86 would have the same performance as its rivals, the XP-80 and XP-84. It was also feared that, because these designs were more advanced in their development stages, the XP-86 would be canceled.

Crucially, the XP-86 would not be able to meet the required top speed of 600 mph (970 km/h); North American had to quickly come up with a radical change that could leapfrog it over its rivals. The North American F-86 Sabre was the first American aircraft to take advantage of flight research data seized from the German aerodynamicists at the end of World War II. This data showed that a thin swept wing could greatly reduce drag and delay compressibility problems which had bedeviled even prop-powered fighters such as the Lockheed P-38 Lightning approaching the speed of sound. By 1944, German engineers and designers had established the benefits of swept wings based on experimental designs dating back to 1940. Study of the data showed that a swept wing would solve their speed problem, while a slat on the wing’s leading edge which extended at low speeds would enhance low-speed stability.

However the idea of changing the sweep of the wing was met with resistance from some senior North American staff. Despite stiff opposition, after good test results were obtained in wind tunnel tests, the swept-wing concept was eventually adopted. Performance requirements were met by incorporating a 35° swept-back wing, and using Modified Aerofoils with an automatic slat design and an electrically adjustable stabilizer, as used by the Messerschmidt Me 262A. Delays caused by the major redesign meant that manufacturing did not begin until after World War II. The XP-86 prototype, which would lead to the F-86 Sabre, was rolled out on 8 August 1947.The United States Air Force’s Strategic Air Command had F-86 Sabres in service from 1949 through 1950. The F-86s were assigned to the 22nd Bomb Wing, the 1st Fighter Wing and the 1st Fighter Interceptor Wing. The F-86 was the primary U.S. air combat fighter during the Korean War. The F-86 Sabre was also produced under license by Canadair, Ltd as the Canadair Sabre. The final variant of the Canadian Sabre, the Mark 6, is generally rated as having the highest capabilities of any Sabre version made anywhere.

The F-86A also set the first official world speed record of 670 miles per hour (1,080 km/h) in September 1948, still some 32 miles per hour (51 km/h) short of the 702 miles per hour (1,130 km/h) unofficial rocket-powered aircraft speed record set with an Me 163B prototype in early July 1944 tests, which itself had a 23.3° wing sweepback angle. Several people involved with the development of the F-86, including the chief aerodynamicist for the project and one of its other test pilots, claimed that North American test pilot George Welch had unofficially broken the sound barrier in a dive with the XP-86 while on a test flight on 1 October 1947. Chuck Yeager broke the sound barrier on 14 October 1947 in the rocket-propelled Bell X-1 during level flight, making it the first true supersonic aircraft. Five years later, on 18 May 1953, Jacqueline Cochran became the first woman to break the sound barrier, flying a “one-off” Canadian-built F-86 Sabre Mk 3, alongside Chuck Yeager, while Col. K. K. Compton won the 1951 Bendix air race in an F-86A with an average speed of 553.76 mph.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.